What To Do If - AEG BP7304001M User Manual

2. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
3. Pull the door trim to the front to re-
move it.
4. Hold the door glass panels on their top
edge one by one and pull them up out
of the guide
5. Clean the door glass panels.
To install panels follow the procedure in re-
verse. Install the smaller panel first, then the
larger.

WHAT TO DO IF...

WARNING!
Refer to "Safety information" chapter.
Problem
The oven does not heat up
The oven does not heat up
The oven does not heat up
The oven does not heat up
The oven does not heat up
The oven lamp does not oper-
ate
The display shows C1
Possible cause
The appliance is deactivated
The time of day is not set
The necessary settings are not
set
The automatic switch-off is ac-
tivated
The fuse is released
The oven lamp is defective
You want to start the pyrolytic
cleaning but you did not re-
move the shelf support (or
telescopic runners).
What to do if...
B
Solution
Activate the appliance
Set the clock. Refer to "First
setting the time of day"
Make sure, the settings are cor-
rect
Refer to „Automatic switch-
off"
Make sure, if the fuse is the
cause for the malfunction. If
the fuse releases again and
again, refer to an authorized
electrician
Replace the oven lamp.
Remove the shelf support (or
telescopic runners) from the
oven.
25