Operation; Using The Temperature Control Panel - EdgeStar CWR361FD Owner's Manual

Note: Whether your wine
cooler can reach the actual
set temperature depends on
the ambient environmental
conditions.
Caution: If you powered off
the unit, please wait at least
5 minutes before powering it
back on.
7

OPERATION

Using the Temperature Control Panel

Use the left button to adjust the left zone's temperature, and use the right
button to adjust the right zone's temperature. The temperature displayed
can be in Fahrenheit or Celsius. This wine cooler has a temperature
range from 40°F to 65°F for the both zones
This wine cooler has two displays, an Left Zone Display that shows the
temperature in the left section, and a Right Zone Display that shows the
temperature in the right section.
Press the button on the control panel to adjust the temperature in the
left zone. The button will scroll the temperature by one degree
increments. Once you see the desired temperature, stop pressing the
button. Note: While pressing the button, it is normal for the temperature to
descend, and then jump to the highest available range. After about 5
seconds, the set temperature will revert to the current temperature.
Press the button on the control panel to adjust the temperature in the
right zone. The button will scroll the temperature by one degree
increments. Once you see the desired temperature, stop pressing the
button. Note: While pressing the button, it is normal for the temperature to
descend, and then jump to the highest available range. After about 5
seconds, the set temperature will revert to the current temperature.
Allow at least 24 hours before storing your wines and to allow the
temperature to acclimate.
Press the button to turn the inner light on or off.
Press and hold the power button for approximately 3 seconds to turn the
unit's power on or off. The Run Light will illuminate when the unit is
cooling.
The Celsius or Fahrenheit light will be lit depending on what scale
temperature is being displayed. To switch between C and F, press and
hold the and buttons at the same time for approximately 5 seconds
until the temperature scale changes.