Table of Contents
Advertisement
Self Test
Printer
Calibration
Operation
Color Printer/Plotter
Figure 7. Front Control Panel
Self test is initiated by pressing and holding the Cancel switch and then pressing the
Feed/Resume switch. The switches may be released after the self test begins. The
test printout contains various printer status and configuration information.
Printer calibration is accomplished through the Color Registration Adjustment tab in
the Printer Driver.
The C930 can be set to print at 1.5 inches/second or 3 inches/second through the
print driver. Printing will begin if the printer is ready and a print job is sent through
either the ethernet or USB interface. It can spool up to 250 print jobs but will inhibit
receipt of a new job if memory space is less than required to hold a 300 foot plot. If
the job is larger than available memory space, it will be received until memory is full.
The partial job will be printed after which the printer will indicate an error
Sequential print jobs with the same print speed will begin at the next top of form. If
print speed is changed, the first job will be completed before the second is started.
If a job is completed without another job in the queue, the paper will advance to per-
mit tear off at the TOF perforation. This enhances stacking capability because the
TOF is positioned to match the "natural" fold of the stack.
8
Advertisement
Table of Contents
