Setting The Ip Address; Install Printer Driver - Printrex C930 Bulldog User Manual

Install Paper
Output Stacker
Setting the IP
Address
Install Printer
Driver
Color Printer/Plotter
See Figure 2.
1.
Lift flapper bar.
Figure 2. Mount Paper Basket
The IP address is set at the factory to 192.168.168.54. The subnet mask is set to
255.255.255.0, and the Default Gateway is set to 192.168.1.1. These can be reset
with the procedures below.
The C930 IP address and subnet mask are set using a bank of 12 rotary switches
grouped in four sets of three each on the back of the printer. See Figure 1. The port
number is set at 90.
Configuring the Subnet mask and Default Gateway must be done over a network
using an HTTP browser (Internet Explorer, Firefox, etc.) The printer should be con-
nected to a subnet local to the host machine being used, and have its IP set so that
it is different from the host IP only in the last number.
Configure the Subnet mask by browsing to <printer IP>/webconfig. For example,
with the above default settings and a host IP set to 192.168.168.53, browse to:
http://192.168.168.54/webconfig. This page contains the Subnet mask value, and
the Default Gateway value. Both may be set from this page.
The switches, Subnet mask and Default Gateway are set only on power up. All num-
bers are in decimal.
Refer to the README.txt file on the driver disk.
2.
Tilt basket and hook into front
panel slots.
Let basket rotate down and rest
against the front panel.
3