Summary of Contents for Printrex C930 Bulldog
- Page 1 USER GUIDE Color Printer/Plotter for Well Logging Model C930 Bulldog Publication #1028-0094...
-
Page 2: Power And Data Connections
Introduction Power and Data The power cable, USB cable and ethernet cable are included in the shipping carton with the printer. Locations of the connectors on the printer are shown in Figure 1. Connections Rear Panel with Cover Removed Rear Panel with Cover Installed IP Address Most Significant Digit Rotary BCD Switch... -
Page 3: Setting The Ip Address
Install Paper See Figure 2. Output Stacker Lift flapper bar. Tilt basket and hook into front panel slots. Let basket rotate down and rest against the front panel. Figure 2. Mount Paper Basket Setting the IP The IP address is set at the factory to 192.168.168.54. The subnet mask is set to 255.255.255.0, and the Default Gateway is set to 192.168.1.1. - Page 4 See Figures 3, 4, 5 & 6. The C930 requires paper with registration marks on the back (non printing) side. Printrex part number 2316-0017. A low ribbon condition (less than 200 feet) is indicated by flashing the front panel Ribbon indicator.
- Page 5 Pull out ribbon cartridge with printer OPEN. Use handles to start pull, then grasp cartridge at both ends to finish removal. Load ribbon cartridge by first resting cartridge ears on chassis supports. Tilt ribbon cartridge up and slide into printer using handles. See PRINTER CLOSE instructions.
- Page 6 Start with printer OPEN. Fold top sheet over rear box edge. Position box with black marks nearest to the printer as shown. Slide paper box Grasp top sheet into printer. and pull it forward over the rubber rollers. Thread paper into output basket. Next CLOSE printer.
- Page 7 Printer should be turned on and show “OPEN” light on Lower handle slowly. Paper will and “ERROR” light flashing. advance while closing door. Close latches. Prepare for printing by pressing either “FFED/RESUME” button or “CANCEL” button. — If a plot didn’t finish, then that plot can be reprinted from the begining by pressing “FEED/RESUME”...
-
Page 8: Printer Calibration
Figure 7. Front Control Panel Self Test Self test is initiated by pressing and holding the Cancel switch and then pressing the Feed/Resume switch. The switches may be released after the self test begins. The test printout contains various printer status and configuration information. Printer Printer calibration is accomplished through the Color Registration Adjustment tab in the Printer Driver. -
Page 9: Error Handling
Error Handling If an error occurs, the printer will stop, the Ready indicator will go dark and the Error indicator will flash the appropriate error code. If the error was caused by Paper, Ribbon or Open, the associated indicator will also be lit. The Error Codes are two digit numbers represented by a long flash(es) (tens digit) and a short flash(es) (ones digit).