Table of Contents
Advertisement
3.04 Lifting Options
Do not touch live electrical parts.
Disconnect input power conductors from de-en-
ergized supply line before moving unit.
This unit is equipped with one handle mounted onto
the top of the enclosure for hand carrying purposes.
FALLING EQUIPMENT can cause serious per-
sonal injury and equipment damage.
• Lift unit with the handle on top of the enclosure.
• Persons only of adequate physical strength should
lift the unit.
• Use hand cart or similar device of adequate capac-
ity.
• If using a fork lift vehicle, place and secure unit on
a proper skid before transporting.
• Unit has a handle mounted on top of the enclosure
for hand lifting only. Be sure unit is lifted and
transported safely and securely.
HANDLE is not for mechanical lifting.
3.05 Input Power Connections
A. Input Voltage Selection
The Power Supply accepts input voltages from 208V to
230VAC, 50 or 60 Hz, single-phase.
B. Electrical Connections
The power source must conform to local and national
electric codes. Recommended circuit protection and wir-
ing requirements are shown in Appendix I.
C. Opening Power Supply Enclosure
The Cover of the Power Supply must be removed to gain
access to the input power connections inside the unit.
INSTALLATION PROCEDURES
WARNINGS
WARNING
WARNING
Disconnect primary power at the source before as-
sembling or disassembling the Power Supply, torch
parts, or torch and leads assemblies.
1. Remove the four screws securing the Handle and the
Leads Wrap to the top of the Cover.
Mounting Screws
A-01693
Figure 3-1 Handle and Leads Wrap Removal
2. Using a phillips head screw driver remove the ten
screws which secure the Cover to the frame assem-
bly.
12
WARNING
Handle
Mounting Screws
Leads Wrap
Manual 0-2700
Advertisement
Table of Contents
