Power Supply Options And Accessories - Firepower FP-78 Operating Manual

7/8"- 200 volt air plasma cutting power supply
Table of Contents

Advertisement

B. Gas Regulator Assembly Specifications
The following specifications apply to the Gas Regu-
lator Assembly only:
1. Gas regulator maximum gauge pressure
160 psi (11 bar or 11.03 kPa)
2. Maximum input gas pressure
125 psi (8.6 bar or 861 kPa)
2.04 Power Supply Options and
Accessories
Refer to Section 6, Parts Lists, for part numbers
and ordering information.
The following are accessories that are available for this
power supply:
A. Two Stage Air Line Filter
An optional two stage air line filter is available. The
filter will remove moisture and contaminants from
the air stream when using compressed air. The filter
is capable of filtering to at least 5 microns. The filter
assembly is pre-assembled at the factory and need
only be attached to the power supply.
B. Smart Cart
Steel cart on easy rolling 10" pneumatic tires to pro-
vide maximum mobility for the power supply.
Handle is 3/4" tubing with hooks for storage of torch
leads. A tie down strap is also included.
INTRODUCTION
NOTE
10
Manual 0-2700

Advertisement

Table of Contents
loading

Table of Contents