Installation Instructions; Preparing For Installation - Dacor Epicure OB36 Installation Instructions Manual

Epicure outdoor grill

Hide thumbs Also See for Epicure OB36:

Planning manual (55 pages)

Use and care manual (28 pages)

Installation instructions manual (25 pages)

Table Of Contents

Table of Contents

•

Before installing the appliance, make sure the elec-

trical and gas (on tank-less installations) service

meets the requirements specified in the Planning

the Installation section of this manual.

•

This appliance must be installed by a licensed

plumber or gas fitter when installed within the

Commonwealth of Massachusetts.

•

Excessive weight warning: Since the appliance and

grill cart are heavy, install the appliance with the help

of at least one other person.

•

Make sure the power cord is NOT connected to the

electrical outlet while connecting the gas line to the

appliance.

•

Do not apply excessive pressure when tightening

connections and fittings.

•

Do not use plumber's putty or Teflon tape on gas

compression connections. Doing so can defeat the

proper sealing of these fittings.

•

Use only approved gas line thread compound or

tape to seal gas connections.

•

The maximum gas supply pressure to the regulator

must not exceed 1/2 pound per square inch.

Preparing for Installation

Before removing the unit from the box, check the

labeling on the box to make sure that the appliance is

equipped for the gas type to be used. Liquid propane

units are identified by the "LP" designation at the end

of the model number. Do not proceed with installation

if you do not have the correct model. Conversion in the

field from one gas type to another is not permissible.

With the help of an assistant, remove the appliance

and all the parts from the box. Check to make sure all

parts are included.

Remove all shipping materials from the appliance and

peel off the protective plastic coating.

To reduce weight during installation, make sure all

loose parts are removed from the grill.