4x4 hdmi over cat5 matrix with ir pass-through (13 pages)
Summary of Contents for Cable Electronics SW204HD
Page 1
* Learns IR commands, so you can use an existing IR remote to control all switch commands. * Network interfaces for remote PC control. * High Bandwidth and low crosstalk provides maximum picture performance. Cable Electronics, Inc. 3209 Wood Street Garland, Texas 75041 (469)429-9200 Fax (469)429-9205 CE Labs, Inc. SW204HD Matrix Switch...
Page 2
Plug the end of the power supply into the power jack on the unit. Connect the wall transformer into an appropriate wall outlet jack. Connect the devices to be switched and the TV monitors to the jacks on the back of the SW204HD as shown above. Component video cables are not supplied with the switch.
Page 3
Installation / Operation Instructions IR Remote Learning Function 1. Press and hold the power switch for 4 seconds. The power may be in the off or on position. The SW204HD will enter the learning mode and Output 1, LED 1 will flash.
Requirement: External 120 Vac input, 9 or 10 Volt AC output @ 1000mA with a 2.1mm coaxial connector. ACCESSORIES: 1 Power Supply 2 Rack Mount Ears 1 Application CD 1 IR Remote Control 1 Manual Dimensions: 1.75 x 5.5 x 14.6 Weight: 3.7 pounds CE Labs, Inc. SW204HD Matrix Switch...
Page 5
If this product is defective or malfunctions, Cable Electronics will replace or repair this unit (at their option) within a reasonable time. No expressed or implied warranty is made for any...
SW204HD unit to RS232 or USB to match the cable used. Insure the power adapter is connected to the SW204HD. If using USB for first time with the SW204HD, you may want to read the notes at end of this help screen on using USB.
Page 7
Controlling and Monitoring the SW204HD Once connected, the SW204HD may be controlled using the Power, and Select Buttons. The current Power status of the SW204HD is shown next to the Connect status. If power is off, then the following status appears.
Page 8
Re-Naming the Inputs and Outputs A special feature of the SW204HD Controller application is the ability for the user to rename inputs and outputs. Simply by clicking on the output or input label in the graphical status portion of the screen, the user may edit the label text.
When a USB cable is first plugged in between a Windows XP/Vista computer and the SW204HD, a “Found New Hardware” message could pop up. This indicates that the USB serial driver for the SW204HD needs to be installed. Simply, follow the Windows directions for installing the needed driver. Once complete, the SW204HD should work fine with USB.