DIP Switch SW1-SW4 [ ] & [ ] for 1080p with stereo. [ ] &...
Page 9
SW Main PLEASE MAINTAIN THIS SETTING AT ANYTIME FOR REGULAR USE! [1]. Power off the HSW44C. [2]. Set the DIP switch position to Firmware Update Mode. [3]. Power on the HSW44C. [4]. Power off the HSW44C. [5]. Set the DIP switch position to Normal Operation Mode.
Page 10
IR Extender IR Emitter Cable IR Receiver Cable HSW44C HSMR...
Method A: Push Button Method B: IR Remote Control If HSW44C receives the IR commands, the LED will flash. If not, try again. If the setting is correct, the corresponding LED will flash. If not, please press output port select button or repeat step (a) and (b).
Page 14
Method A: Push button Method B1: IR remote control for switching input channels Note If HSMR receives the IR command, the LED will flash. If not, try it again. Method B2: IR remote control for controlling the HDMI sources...