Lubrication Points - Yamaha SUPERJET 700 2005 Owner's/Operator's Manual

NOTE:
@
G Wipe off any water on the spark plug or
inside the cap before installing the spark
plug cap. Push the spark plug cap down
until it is securely installed.
G If a torque wrench is not available when
you are installing a new spark plug, a good
estimate of the correct torque is 1/4 turn to
1/2 turn past finger tight with the spark
plug wrench included in the tool kit. Have
the spark plug adjusted to the correct
torque with a torque wrench as soon as
possible.
@
WARNING
@
Be careful not to damage the insulator
when removing or installing a spark plug.
A damaged insulator could allow sparks
to escape, which could lead to an explo-
sion or fire.
@
EJU13021

Lubrication points

To keep moving parts sliding or rotating
smoothly, coat them with water-resistant
grease.
Recommended water resistant grease:
Yamaha Marine Grease/
Yamaha Grease A
G
Throttle cable (carburetor end)
G Choke cable (carburetor end)
G Throttle cable (handlebar end)
Pull the throttle lever and remove the
seal 1. Spray a rust inhibitor into the
outer cable. Refit the seal securely.
4-14
E