Yamaha FX High Output WaveRunner 2005 Owner's/Operator's Manual page 74

EJU18352
Switches
CAUTION:
@
Do not run the engine of the watercraft
for more than 15 seconds on land with-
out supplying
engine may overheat.
@
Check the start switch, the engine stop
switch, and the engine shut-off switch for
proper operation.
Push the start switch 1 to start the
engine. As soon as the engine starts run-
ning, push the engine stop switch 2 to ver-
ify that the engine stops immediately.
Restart the engine, and then pull the engine
shut-off cord 5 to remove the clip 4 from
the engine shut-off switch 3 to verify that
the engine stops immediately. (See pages
2-9 to 2-10 for information on proper opera-
tion of the start switch, the engine stop
switch, and the engine shut-off switch.)
EJU18060
Cooling water pilot outlet
Check that water comes out from the port
(left) pilot water outlet while the engine is
running and the watercraft is in the water.
(See page 2-11 for further instructions.)
EJU12460
Multifunction meter
Check the operation of the multifunction
meter. (See pages 2-21 to 2-26 for operation
of the meter.)
3-17
water, otherwise
E
the