Saddlebags [Xv17At(C)] - Yamaha Road Stan XV17AT Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
To change the windshield height
1. Remove the bolts on each side of
the windshield.
2. Move the windshield to the other
position.
3. Install the bolts and tighten them to
the specified torque.
3
Tightening torque:
Windshield bolt:
16 Nm (1.6 m·kgf, 12 ft·lbf)
4. Loosen the screws holding the
windshield cover located above
the headlight, position the cover
close to the headlight without
touching it, and then tighten the
screws.
1. Windshield cover
2. Screw
WARNING
After adjusting the windshield:
G
Securely tighten the windshield
bolts.
G
Turn the handlebar to the left
and right to make sure that the
handlebar is not obstructed and
that the windshield does not
contact any other parts.
G
Open the throttle and make sure
that the throttle grip returns
properly when released, other-
wise an accident or injury could
result.
3-12
EWA10920

Saddlebags [XV17AT(C)]

WARNING
Improper loading or overloading can
cause loss of control and possibly
an accident or personal injury. See
pages 1-5 and 6-17 for important
loading and tire pressure informa-
tion.
G Always securely close each
saddlebag before riding.
G
Distribute weight evenly on
each side of the motorcycle.
G
Do not exceed the load limit of 5
kg (11 lb) for each saddlebag.
G Do not exceed the maximum
load of XV17AT(C) 179 kg (395
lb) for the vehicle.
G
Do not exceed 120 km/h (80
mi/h) when riding with luggage
in the sidecases, otherwise han-
dling could be affected. Improp-
er loading, poor tire or overall
motorcycle
road surfaces or adverse weath-
er conditions may make it nec-
essary to further reduce the
riding speed.
EAU14613
EWA11111
conditions, poor