Yamaha ROAD STAR XV16A Owner's Manual page 64

1. Engine oil filter cartridge
9. Install the engine oil drain bolts,
and then tighten them to the spec-
ified torque.
Tightening torque:
Engine oil drain bolt:
31 ft·lb (4.3 m·kgf, 43 Nm)
10. Pour only 2.6 US qt (2.2 Imp qt,
2.5 L) of the specified amount of
recommended engine oil through
the filler hole, insert the dipstick,
and then tighten the oil filler cap.
11. Start the engine, rev it several
times, and then turn it off.
PERIODIC MAINTENANCE AND MINOR REPAIR
12. Remove the engine oil filler cap,
and then gradually fill the oil tank
with the remaining oil quantity
while regularly checking the oil
level on the dipstick.
Recommended engine oil:
See page 8-1.
Oil quantity:
Without oil filter cartridge
replacement:
3.9 US qt (3.3 Imp qt, 3.7 L)
With oil filter cartridge
replacement:
4.3 US qt (3.6 Imp qt, 4.1 L)
Total amount (dry engine):
5.3 US qt (4.4 Imp qt, 5.0 L)
6-12
CAUTION:
_
●
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives with
the oil or use oils of a "CD"
grade or higher. In addition, do
not use oils labeled "ENERGY
CONSERVING II" or higher.
● Make sure that no foreign mate-
rial enters the crankcase.
_
13. Install the engine oil filler cap.
14. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
15. Turn the engine off, and then
check the oil level and correct it if
necessary.
EC000072*
6