Handlebar Switches - Yamaha ROAD STAR XV16A Owner's Manual

1. Dimmer switch " / "
2. Turn signal switch " "
3. Horn switch " "

Handlebar switches

Dimmer switch " / "
Set this switch to " " for the high
beam and to " " for the low beam.
Turn signal switch " /
To signal a right-hand turn, push this
switch to the right. To signal a left-hand
turn, push this switch to the left. When
released, the switch returns to the cen-
ter position.
INSTRUMENT AND CONTROL FUNCTIONS
Since this model is equipped with a
self-canceling system, the turn signal
lights will self-cancel after the motor-
cycle has traveled both about 150 m
(490 ft) and for approximately 15 sec-
onds. However, the turn signal lights
can also be canceled manually by
pushing the switch in after it has re-
turned to the center position.
NOTE:
_
The self-canceling system only oper-
EAU00118
ates when the motorcycle is moving, so
that the turn signal lights will not self-
cancel while you are stopped at an in-
EAU03888
tersection.
_
Horn switch "
Press this switch to sound the horn.
EAU04078
"
4. Engine stop switch "
5. Start switch "
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the motorcycle over-
turns or when the throttle cable is
EAU00129
stuck.
"
Start switch "
Push this switch to crank the engine
with the starter.
CAUTION:
@
See page 5-1 for starting instruc-
tions prior to starting the engine.
@
3-6
/ "
"
EAU03890
/ "
" before starting
" to
EAU00143
"
EC000005
3