Yamaha Venture XVZ13TFT Owner's Manual page 20

INSTRUMENT AND CONTROL FUNCTIONS
High beam indicator light "
This indicator light comes on when the
high beam of the headlight is switched
on.
Oil level warning light "
This warning light comes on when the
3
engine oil level is low.
The electrical circuit of the warning light
can be checked according to the follow-
ing procedure.
1. Set the engine stop switch to "
and turn the key to "ON".
2. Shift the transmission into the neu-
tral position or pull the clutch lever.
3. Push the start switch. If the warn-
ing light does not come on while
pushing the start switch, have a
Yamaha dealer check the electri-
cal circuit.
NOTE:
Even if the oil level is sufficient, the
warning light may flicker when riding on
a slope or during sudden acceleration
or deceleration, but this is not a mal-
function.
EAU11080
" Fuel level warning light " "
This warning light comes on when the
fuel level drops below approximately
3.5 L (0.92 US gal) (0.77 Imp.gal).
When this occurs, turn the fuel cock le-
ver to the "RES" position and refuel as
EAU11140
"
soon as possible.
Cruise control indicator lights
See page 3-5 for an explanation of
these indicator lights.
"
Coolant temperature warning light
" "
This warning light comes on when the
engine overheats. When this occurs,
stop the engine immediately and allow
the engine to cool.
The electrical circuit of the warning light
can be checked according to the follow-
ing procedure.
1. Set the engine stop switch to "
and turn the key to "ON".
2. Shift the transmission into the neu-
tral position or pull the clutch lever.
EAU11270 3. Push the start switch. If the warn-
CAUTION:
Do not operate the engine if it is
overheated.
EAU11380
Overdrive indicator light "O/D"
This indicator light comes on when the
transmission is in overdrive (5th gear).
EAU11410
Engine trouble warning light "
This warning light comes on or flashes
when an electrical circuit monitoring the
engine is defective. When this occurs,
have a Yamaha dealer check the self-
diagnosis system.
"
3-3
ing light does not come on while
pushing the start switch, have a
Yamaha dealer check the electri-
cal circuit.
ECA10020
EAU11450
EAU11470
"