Handlebar Switches - Yamaha GRIZZLY Ultramatic YFM660FP Owner's Manual

EBU00053

Handlebar switches

1. Light switch
2. Engine stop switch
3. Start switch " "
EBU00735
Light switch
Turn the switch to the "
on the low beam and the taillight.
Turn the switch to the "
on the high beam and the taillight.
Turn the switch to the "OFF" position to switch
off the headlight and the taillight.
" position to switch
" position to switch
CAUTION:
Do not use the headlight with the engine
turned off for more than thirty minutes.
The battery may discharge to the point
that the starter motor will not operate
properly. If this should happen, remove
the battery and recharge it.
EBU00606
Engine stop switch
Make sure that the engine stop switch is in the
" " position. The engine stop switch controls
ignition and can be used at all times to stop
the engine, especially in an emergency. The
engine will not start or run when the engine
stop switch is turned to "
4-7
".