Lubrication - Yamaha AR230 Owner's/Operator's Manual

4
M
AINTENANCE
4) Turn off the water supply, then drain
residual water from the exhaust
system by alternately pushing the
throttle lever up to half throttle and
back for 10 to 15 seconds. Shut off
engine.
CAUTION:
Never have the water on when the
engine is not running. The water
could flow back through the muffler
into the crankcase causing severe
engine damage. Do not run the engine
for more than 15 seconds after the
water supply has been turned off to
avoid engine overheating.
5) After stopping the engine, remove
the garden hose adapter.
6) Replace the cap securely.
7) Repeat the flushing procedure for
the other engine.

LUBRICATION

WARNING
Do not spray flammable rust inhibi-
tor on engine surfaces while the
engines are hot. The sprayed sub-
stance or propellants could catch
fire.
& C
ARE
1) Open the hood (see page 2-17).
2) Remove the air filter case cover
3) Remove the air filter element.
4) Spray a rust inhibitor such as
5) Install the air filter element and air
6) Start the engine in a well-ventilated
CAUTION:
Do not run the engine for more than
15 seconds. The engine could over-
heat.
4-2
screws 1, slide the locks 2 to
open, and then remove the case
cover.
Yamaha Store-Rite Fogging Oil into
each intake opening 3 for 3 sec-
onds.
filter case cover.
area and let it run at idle for 15 sec-
onds.