Yamaha AR230 Owner's/Operator's Manual page 45

Lights
This toggle switch controls the required
on-board lighting. Press the top of the
switch to turn on both the bow light
and stern light for night running. Press
the bottom of the switch to operate the
stern light alone when anchored at
night. Put the switch in the middle posi-
tion to turn off all lights (see page 3-9).
Horn
Pressing this switch activates the horn.
The horn can be used to signal other
boats as required by the "Rules of the
Road" (see page 1-15).
NOTE: The helm switches will not work
if the battery switch in the battery com-
partment is turned to the off position.
See page 4-3 for more information.
No Wake Mode
The No-Wake Mode System is useful
for operating the boat at a steady speed
with a minimal wake. This is especially
convienient when traveling in harbors,
channels, or other areas posted with
low speed limits as "no-wake zones."
No-Wake Mode can be engaged
when the throttles are at idle speed in
Forward, Neutral, or Reverse. Engine
speed will be set at 2400 rpm for con-
venient, no-wake maneuvering.
To set No-Wake Mode:
Press both gray No-Wake Mode buttons
simultaneously until the three symbols
in each tachometer start blinking.
F & F
EATURES
N
4
3
2
1
0
NOTE: Although each engine is con-
trolled separately, always put both
engines in No-Wake Mode for proper
operation.
To cancel the No-Wake Mode, do any
of the following:
Press both No-Wake Mode buttons
again.
Move the accelerator levers to a faster
engine speed.
Shut off the engines with the key or by
using the engine stop switch lanyard.
WARNING
Once the engines have stopped,
you have NO STEERING CONTROL
over the boat. You could collide with
another boat, a dock, or other obsta-
cle.
2-15
UNCTIONS
PORT
5 6
7
8
9
10
11
PORT STBD
2
STBD