Yamaha TT-R Owner's Manual page 78

PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
1. Swingarm end cover (×2)
2. Screw (×4)
2. Lift the rear wheel off the ground
according to the procedure on
page 6-33.
6
3. Remove each swingarm end
cover by removing the screws.
2
4. Push the wheel forward, and
then remove the drive chain from
the rear sprocket.
NOTE:
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
5. Remove the wheel.
cC
Do not apply the brake after the
wheel has been removed together
with the brake disc, otherwise the
brake pads will be forced shut.
6-37
To install the rear wheel
1. Install the wheel.
NOTE:
Make sure that there is enough
space between
before inserting
between the pads.
2. Install the drive chain onto the
rear sprocket.
3. Install each swingarm end cover
by installing the screws, and then
lower the rear wheel so that it is
on the ground.
4. Adjust the drive chain slack.
(See page 6-23 for drive chain
slack adjustment procedures.)
5. Tighten the axle nut to the speci-
ECA00048
fied torque, and then install the
cotter pin.
Tightening torque:
Axle nut:
105 Nm
(10.5 m0kgf, 76 ft0lbf)
EAU04368
the brake pads
the brake disc