Starting The Engine - Yamaha YZF-R6 Owner's Manual

O PERATION AND IMPORTANT RIDING POINTS
5 -
WARNING
@
G
Become thoroughly
with all operating controls and
their functions before riding.
Consult a Yamaha dealer re-
garding any control or function
that you do not thoroughly un-
derstand.
G
Never start the engine or oper-
ate it in a closed area for any
length of time. Exhaust fumes
5
are poisonous, and inhaling
them can cause loss of con-
sciousness and death within a
short time. Always make sure
that there
ventilation.
G
Before starting out, make sure
that the sidestand is up. If the
sidestand is not raised com-
pletely, it could contact the
ground and distract the opera-
tor, resulting in a possible loss
of control.
@
EAU00373

Starting the engine

In order for the ignition circuit cut-off
familiar
system to enable starting, one of the
following conditions must be met:
G
The transmission is in the neutral
position.
G
The transmission is in gear with
the clutch lever pulled and the
sidestand up.
WARNING
_
G
Before
check the function of the igni-
tion circuit cut-off system ac-
cording
described on page 3-29.
is adequate
G
Never ride with the sidestand
down.
_
1. Turn the key to "ON" and make
sure that the engine stop switch is
set to "
EAU04953
EW000054
starting the engine,
to the procedure
".
5-1
CAUTION:
_
The following warning lights and in-
dicator light should come on for a
few seconds, then go off.
G
Oil level warning light
G
Fuel level warning light
G Coolant temperature warning
light
G
Shift timing indicator light
G
Engine trouble warning light
G Immobilizer system indicator
light
If a warning or indicator light does
not go off, see pages 3-4–3-7 for the
corresponding warning and indica-
tor light circuit check.
_
2. Shift the transmission into the neu-
tral position.
NOTE:
_
When the transmission is in the neutral
position, the neutral indicator light
should be on, otherwise have a
Yamaha dealer check the electrical cir-
cuit.
_
EAU00372
ECA00147