Yamaha YZF-R6 Owner's Manual page 28

INSTRUMENT AND CONTROL FUNCTIONS
NOTE:
_
G
To make any settings in this mode,
you have to cycle through all of its
functions. However, if the key is
turned to "OFF" or the engine is
started before completing the pro-
cedure, only the settings made be-
fore the "SELECT" button was last
3
pushed will be applied.
G
In this mode, the multi-function
display shows the current setting
for each function (except the shift
timing indicator light activity func-
tion).
_
To adjust the display brightness
1. Turn the key to "OFF".
2. Push and hold the "SELECT" but-
ton.
3. Turn the key to "ON", and then, af-
ter five seconds, release the
"SELECT" button.
4. Push the "RESET" button to select
the desired display brightness lev-
el.
5. Push the "SELECT" button to con-
firm the selected display bright-
ness level. The control mode
changes to the shift timing indica-
tor light activity function.
3-11
To set the shift timing indicator light ac-
tivity function
1. Push the "RESET" button to select
one of the following indicator light
activity settings:
a. The indicator light will stay on
when activated. (This setting is se-
lected when the indicator light
stays on.)
b. The indicator light will flash when
activated. (This setting is selected
when the indicator light flashes
four times per second.)
c. The indicator light is deactivated;
in other words, it will not come on
or flash. (This setting is selected
when the indicator light flashes
once every two seconds.)
2. Push the "SELECT" button to con-
firm the selected indicator light ac-
tivity. The control mode changes
to the shift timing indicator light ac-
tivation function.