Rear Wheel Installation - Yamaha Virago XV125S Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1
1
2
5
3
1. Cotter pin
4
2. Alignment marks
3. Locknut
4. Chain adjusting nut
5
5. Axle nut
5. Remove the rear brake pedal
6 free play adjusting nut and
brake rod from the brake cam
lever.
7
6. Loosen the locknuts and chain
adjusting nuts on each side.
8
7. Remove the axle nut.
8. Pull out the wheel axle and
9
remove the wheel assembly.

Rear wheel installation

2
1. Install the rear wheel and the
axle.
2. Install the axle nut and let the
motorcycle down.
3
4
3. Insert the brake rod into the
brake cam lever and install the
brake pedal free play adjusting
nut.
4. Install the brake torque rod
bolt and tighten to the speci-
fied tightening torque. Then
install a new cotter pin.
Specified torque:
Brake torque rod bolt:
5. Adjust the drive chain free
play. (See page 6-25.)
6. Tighten the axle nut to the
specified tightening torque.
Specified torque:
Axle nut:
EAU01696
23 Nm (2.3 m·kg)
105 Nm (10.5 m·kg)
6-39
7. Adjust the rear brake pedal
height and free play. (See page
6-21.)
w
Check the operation of the brake
light after adjusting the rear brake.
EW000103