Rear Wheel - Yamaha V-star XVS650P Owner's Manual

5. Push down hard on the handlebar
several times to check for proper
fork operation.
6. Tighten the wheel axle to the
specified torque, and then install
the rubber cap.
Tightening torque:
Wheel axle:
59 Nm (5.9 m·kgf, 43 ft·lb)
7. Tighten the front wheel axle pinch
bolt to the specified torque.
Tightening torque:
Front wheel axle pinch bolt:
20 Nm (2.0 m·kgf, 14 ft·lb)
8. Connect the speedometer cable.
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Axle nut

Rear wheel

To remove the rear wheel
WARNING
@
● It is advisable to have a Yamaha
dealer service the wheel.
● Securely support the motor-
cycle so that there is no danger
of it falling over.
@
1. Loosen the axle nut.
6-38
1. Brake pedal free play adjusting nut
2. Brake camshaft lever
EAU01350
3. Brake rod
4. Bolt (shoe plate)
5. Brake torque rod
6. Bolt (swingarm)
EW000122
2. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the bolt.
3. Loosen the brake torque rod bolt
at the swingarm.
4. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod from the brake cam-
shaft lever.
5. Remove panel A. (See page 6-8
for panel removal and installation
procedures.)
6