Adjusting The Screen Brightness - XPLORE TECHNOLOGIES GeneSys User Manual

Turning Power On
Although we are sure these instructions are unnecessary, we have included these simple instructions
for reasons of completeness. To turn on the power follow these steps:
1. Connect the computer to AC power
2. Press the power button, which is located on the membrane switch (see Chapter 3)
3. Depress the power button for approximately 2 seconds to initiate system response
Note: Do not turn power off immediately after turning on the system. Instead, wait until the operating
system completes booting.
When the power is turned on, the power indicator (on the gray panel above the LCD) lights and the
computer starts.

Adjusting the Screen Brightness

Brightness adjustment buttons have been provided to allow for adjustment for maximum readability.
Screen
Brightness
Screen
Figure 2.3 Screen Brightness Adjustment for GeneSys II
Brightness
Figure 2.4 Screen Brightness Adjustment for GeneSys Maximus
Removing the Grips
All grips will require minimal effort to remove. However, in the event that the user experiences
difficulty removing any grip, use the follow these steps:
1. Remove the grip above the grip that covers the battery cover (top left grip).
2. Place the edge of the grip on the edge of a table or firm surface (See Figure 3).
3. Slowly but firmly push the tablet down while a table or firm surface supports the edge of the
grip. (See Figure 4).
4. Remove the grip by hand.
October 2001 Page 14 P/N 96-000001-017, Version Q301