Chapter 2: Quick Start; Connecting To Ac Power - XPLORE TECHNOLOGIES GeneSys User Manual

Quick Start
Your computer is designed and pre-configured for easy setup and use. This chapter describes the
steps you should follow to get your GeneSys System up and running as quickly as possible. You
should read this chapter first. Although many of the instructions and recommendations are common
sense, we want to ensure that you have your GeneSys System configured as quickly as possible.
We recommend that you read the entire manual for a comprehensive overview of the entire GeneSys
system and its operation.

Connecting to AC Power

The rechargeable battery pack, AC adapter or DC adapter can power the computer. See the next
chapter for more information on power sources. The first time you use the computer, be sure to
perform the steps below:
1. Make sure the computer is turned off.
2. Connect the AC adapter cord to the computer.
3. Connect the AC power cord to the AC adapter.
[WARNING] – Always use the AC adapter supplied with the computer. Using other
AC adapters may damage the computer. Always hold the AC adapter cord by its
plug.
4. Plug the AC power cord into a wall outlet.
GeneSys Tablet
Attach AC/DC
Input
Figure 2.1 Connecting to AC Power
Note: Alternatively power may be provided by an optional external DC automobile adaptor or
connected directly via the GeneSys Xpander and Quick Release Docks for in-vehicle, forklift or
mobile communication cart installation.
October 2001
Attach cord
set
AC Brick/ adapter
Figure 2.2 Turning Power ON
Page 13
C
HAPTER
GeneSys
Power Controls
P/N 96-000001-017, Version Q301
2