Using The S-Video Out Or The Component Video Out Jacks And The Audio Out Jacks (Only For Dvd); Connecting To External Equipment - Toshiba D-VR16SB Owner's Manual

Using the S-VIDEO OUT or the
COMPONENT VIDEO OUT jacks
and the AUDIO OUT jacks (Only
for DVD)
If your TV has an S-Video or a Component Video input
jack, use either an S-Video cable (to connect the
S-VIDEO OUT jack) or a Component Video cable (to
connect the COMPONENT VIDEO OUT jacks), and an
Audio Cable (to connect the AUDIO OUT jacks).
- S-Video connection provides the good quality picture.
- Component connection provides the better quality picture.
1) Follow steps 1 and 2 on page 26.
2) Connect S-VIDEO OUT or COMPONENT VIDEO
OUT jacks of this unit to the S-Video or
Component Video input jacks of your TV. Use a
commercially available S-Video cable or
Component video cable.
3) Connect the AUDIO OUT jacks of this unit to
the analogue Audio input jacks of your TV. Use
a commercially available Audio cable.
AUDIO IN S-VIDEO IN
Audio S-Video
cable
cable
(not (not
supplied)
supplied)
DVD/VCR
AV2(DECODER)
AV1(TV)
Note for a TV with no S-Video input jack or Scart socket:
• This unit has no RF modulator, so this type of TV cannot
be used.
• Only component connection is compatible with the
Progressive Scan.
Component
Video IN
Y P /C P /C
B B R R
Component
Video Cable
(not
supplied)
DVD ANTENNA
DIGITAL AUDIO S-VIDEO COMPONENT
AUDIO OUT OUT OUT VIDEO OUT
Y
IN
P
L B
/C
B
COAXIAL
P
R R
/C R
OUT

Connecting to external equipment

This unit has three input terminals, AV1, AV2 on the rear
panel and AV3 on the front panel. Be sure that all the
units are off before making connections.
■ Recording from a DVD player, VCR or other
Audio-Video equipment with a Scart output
jack (AV2)
Scart cable (not supplied)
DVD/VCR
AV2(DECODER)
AV1(TV)
Note
• If the external equipment connected to the AV2 jack
supplies control voltage to this unit via Pin 8 of the Scart
cable, the display functions (e.g. P01) of the remote
control cannot be seen on the TV connected to the AV1.
In this case, turn off the external equipment to prevent
control voltage.
■ Recording from a camcorder or other Audio-
Video equipment with no Scart output jack
(AV3)
AV3(Front)
DUBBING VCR/DVD REC
DVD
VCR DVD
AV3 S-VIDEO
S-Video cable
(not supplied)
S-VIDEO
OUT
Change the setup. (See page 58.)
If no S-Video input jack is available, connect to Video
input jack on the front panel using an RCA Video cable.
AV output jack
(Scart)
AV2 (DECODER)
DVD ANTENNA
DIGITAL AUDIO S-VIDEO COMPONENT
AUDIO OUT OUT OUT VIDEO OUT
Y
IN
P
L B
/C
B
COAXIAL
R P
R
/C R
OUT
VIDEO L R
Audio cable
(not supplied)
AUDIO
OUT
EN 27