Log Table - TP-Link TL-SG3210 User Manual

The Log function is implemented on the Log Table, Local Log, Remote Log and Backup Log
pages.

14.2.1 Log Table

The switch supports logs output to two directions, namely, log buffer and log file. The information
in log buffer will be lost after the switch is rebooted or powered off whereas the information in log
file will be kept effective even the switch is rebooted or powered off. Log Table displays the system
log information in log buffer.
Choose the menu Maintenance→Log→Log Table to load the following page.
The following entries are displayed on this screen:
Log Info

Index:
Time:
Module:
Severity:
Content:
Note:
1. The logs are classified into eight levels based on severity. The higher the information severity
is, the lower the corresponding level is.
2. This page displays logs in the log buffer, and at most 512 logs are displayed.
Figure 14-3 Log Table
Displays the index of the log information.
Displays the time when the log event occurs. The log can get the
correct time after you configure on the System ->System
Info->System Time Web management page.
Displays the module which the log information belongs to. You can
select a module from the drop-down list to display the corresponding
log information.
Displays the severity level of the log information. You can select a
severity level to display the log information whose severity level value
is the same or smaller.
Displays the content of the log information.
205