Appearance Description; Front Panel - TP-Link TL-SG3210 User Manual

2.3 Appearance Description

2.3.1 Front Panel

The following parts are located on the front panel of the switch:
 10/100/1000Mbps Ports: Designed to connect to the device with a bandwidth of 10Mbps,
100Mbps or 1000Mbps. Each has a corresponding 1000Mbps LED.
 SFP Ports: Designed to install the SFP module. TL-SG3216/TL-SG3424 switch features some
SFP transceiver slots that are shared with the associated RJ45 ports. The associated two ports
are referred to as "Combo" ports, which means they cannot be used simultaneously, otherwise
only SFP ports work. TL-SG3210 features two individual SFP ports.
Note:
For TL-SG3216/TL-SG3424 switch, when using the SFP port with a 100M module or a gigabit
module, you need
Switching→Port→Port Config page. For 100M module, please select 100MFD while select
1000MFD for gigabit module. By default, the Speed and Duplex mode of SFP port is 1000MFD.
For TL-SG3210, it only supports 1000MFD mode.
 Console Port: Designed to connect with the serial port of a computer or terminal for monitoring
and configuring the switch.
 LEDs
Name
Power
System
1000Mbps
Link/Act
Figure 2-1 Front Panel
to configure its
Status
On Power is on.
Flashing Power supply is abnormal.
Off Power is off or power supply is abnormal.
On The switch is working abnormally.
Flashing The switch is working normally.
Off The switch is working abnormally.
A 1000Mbps device is connected to the corresponding
On
port.
A 10/100Mbps device or no device is connected to the
Off
corresponding port.
A device is connected to the corresponding port, but not
On
activity.
Flashing Data is being transmitted or received.
Off No device is connected to the corresponding port.
corresponding Speed
Indication
7
and Duplex mode on