TP-Link TL-SG3210 User Manual page 209

Configuration Procedure

Configure the member switch

Step Operation
1 Enable NDP function on the
switch and for port 1
2 Enable NTDP function on the
switch and for port 1
Configure the commander switch

Step Operation
1 Enable NDP function on the
switch and for port 1, port 2 and
port 3
2 Enable NTDP function on the
switch and for port 1, port 2 and
port 3
3 Create a cluster and configure
the related parameters
Figure 13-15 Network diagram
Description
On Cluster→NDP→NDP Config page, enable NDP
function.
On Cluster→NTDP→NTDP Config page, enable
NTDP function.
Description
On Cluster→NDP→NDP Config page, enable NDP
function.
On Cluster→NTDP→NTDP Config page, enable
NTDP function.
On Cluster→Cluster→Cluster Config page, configure
the role as Commander and enter the related
information.
IP pool: 175.128.0.1
Mask: 255.255.255.0
200