Table of Contents
Advertisement
FUNCTIONAL
DESCRIPTION
2
1. Battery cartridge
2. Button
1
1. Lever
1
1. Clamping screw
2. Bevel scale plate
1
B
2
1. Base
2. Cutting line
CAUTION:
•
Always be sure that the tool is switched off and the battery cartridge is
removed before adjusting or checking function on the tool.
Installing or removing battery cartridge
001328
•
Always switch off the tool before insertion or removal of the battery
1
cartridge.
•
To remove the battery cartridge, withdraw it from the tool while pressing
the buttons on both sides of the cartridge.
•
To insert the battery cartridge, align the tongue on the battery cartridge
with the groove in the housing and slip it into place. Always insert it all
the way until it locks in place with a little click. If not, it may accidentally
fall out of the tool, causing injury to you or someone around you.
•
Do not use force when inserting the battery cartridge. If the cartridge
does not slide in easily, it is not being inserted correctly.
Adjusting depth of cut
001351
CAUTION:
•
After adjusting the depth of cut, always tighten the lever securely.
Loosen the lever on the side of the rear handle and move the base up or
down. At the desired depth of cut, secure the base by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more than one blade tooth
projects below workpiece. Using proper cut depth helps to reduce potential for
dangerous KICKBACKS which can cause personal injury.
Bevel cutting
001368
Loosen the clamping screw on the bevel scale plate on the front of the base.
Set for the desired angle (0° - 50°) by tilting accordingly, then tighten the
clamping screw securely.
2
Sighting
001386
For straight cuts, align the A position on the front of the base with your cutting
line. For 45° bevel cuts, align the B position with it.
A
7
Advertisement
Table of Contents
