Golden Technologies Compass Sport GP605 SS Owner's Manual page 13

Compass Sport Owner's Manual – Model # GP605 SS, GP605 CC
ASSEMBLY / DISASSEMBLY
SEAT INSTALLATION/REMOVAL
Note: The seat assembly weighs about 46 pounds. Please ask for help if you do
not feel capable of safely lifting that much weight. Removal of arms will
significantly reduce the weight of seat.
INSTALLATION
1. To install the seat, align the seat post stinger on the bottom of the seat with
the hole in the seat post receiver on the chair. See figures 3 and 4 on page 13.
2. Lift the seat lock lever and while holding the lever rotate the seat until it
aligns and seats into place. See figure 2 on page 13.
3. Attach arms by loosening the arm width adjustment knobs (See figure 16 on
Page 21). Insert left arm into left receiving tube and tighten the arm width
adjustment knob. Repeat with right arm.
4. Attach joystick to right arm. (See Joystick Installation/Removal on page 14.)
5. Connect the controller cable to the joystick and use the Velcro tie-wraps to
secure the cable to the armrest bracket.
6. Lift the Backrest Angle Adjustment Lever (See Figure 1 on page 13) and while
holding the lever, lift the seat back to an upright angle.
REMOVAL
1. Disconnect the controller cable from the joystick. See figure 6 on page 14.
Remove Velcro tie-wraps from the controller cable.
2. Remove arms by loosening the arm width adjustment knobs and pulling arms
out of the receiving tubes.
3. With one hand brace the seat back. With the other hand lift the Backrest
Angle Adjustment Lever and while holding the lever, lower the back of the seat
to the seat.
4. Lift the seat lock handle and while holding the lever rotate the seat and lift the
seat off the seat post receiver. See figure 2 on page 13.
LOCKED BEFORE OPERATING YOUR POWER CHAIR.
Lifting the Backrest Angle Adjustment Lever will cause the back to
automatically close towards the seat. Improper handling may
result in injury.
BE SURE THE SEAT IS CORRECTLY INSTALLED AND
12
Revised 11/12/10