Advertisement
Harness requires direct connection to
vehicle battery. Do not connect harness
to a secondary power source.
Unwind the harness and lay it flat on the ground. One end of
the harness has a black plug; this runs to the back of the
vehicle.
BEGIN ROUTING THE HARNESS AT THE VEHICLE BATTERY.
Connect the black wire to the negative terminal of the battery.
Do not connect the positive terminal yet.
Run wiring harness under, or if possible, through the vehicle,
using cable ties provided to secure the harness to the vehicle.
Position the harness away from the fuel tank, exhaust sys-
tem, brake and fuel lines and any possible pinch points.
Harness should be positioned where it will not come in con-
tact with any road debris.
The harness may be too long for the vehicle. DO NOT CUT
OR SHORTEN THE HARNESS. Use cable ties provided to coil
excess wire and secure it to the vehicle frame.Rear plug
should be secured even to the vehicle's trailer hitch.
Connect the red wire to the positive battery
terminal.
Wire in a standard 4-contact female flat trailer
connector to the vehicle's taililights. This will
provide power for the motor cover light.
Vehicle Wiring Instructions
To vehicle's
battery
Side mount
COIL
EXCESS
WIRE
HERE
XCESS
WIRE
HERE
Side mount
To back
of vehicle
OR
Top mount
Coil
Excess Wire
Here
OR
OR
Top mount
BROWN WIRE
TRAILER PLUG
ON LIFT HARNESS
Ground for light is
provided by main
2 prong power
connector
MOTOR COVER
LIGHT
Advertisement
