Table of Contents
Advertisement
With Macintosh
1.
With the M-1000 disconnected, start up your computer.
2.
Run "M-1000 USB Installer J" on the included CD-ROM.
3.
Follow the instructions displayed to install the special driver.
4.
Re-boot your computer.
5.
Connect the M-1000 and the computer with a USB cable.
6.
Turn on the M-1000. If in Advanced mode (ADVANCED indicator lit),
press the CLOCK SOURCE button to switch to Standard Driver mode
(ADVANCED indicator off), and turn the M-1000 off and then on again.
7.
Wait five seconds for the standard drivers to be recognized automatically,
then go to Control Panels in the Apple menu and open the "Sound" control
panel. For "Input," specify "USB Audio" (required when using the
standard driver).
8.
Uncheck the "Play sound through output device" option.
9.
Switch the M-1000 to Advanced mode (the ADVANCED indicator should
flash; turn the M-1000 off and then on again).
10. On the included CD-ROM, go to "Driver"
16bit" and "M-1000 ASIO1.0 24bit." Copy all of the drivers in the folder for
the ASIO-supported software you will be using to the "ASIO Drivers"
folder.
11. Specify "M-1000 ASIO1.0 16bit" or "M-1000 ASIO1.0 24bit" in the settings
screen in each ASIO application.
Deleting the Special Drivers (Uninstall)
If the special driver is not installed according to the prescribed procedure, or if there
is some other problem, the computer may fail to recognize the M-1000. If this occurs,
first delete then reinstall the special driver.
For the exact procedure, refer to the document on the CD-ROM included with the M-
1000.
Windows
CD-ROM
"Driver" folder
ReadMe_E.htm"
"
Macintosh
CD-ROM
"Driver" folder
ReadMe_E.htm"
"
"ASIO"
operating system version you are using
ReadMe"
English"
"
folder
"
"M-1000 ASIO1.0
folder
USB Audio
During the re-boot procedure,
USB indicator or internal
indicator (INT) of M-1000
irregulary blinks. But this is
not malfunction.
Please confirm USB indicator
lits after re-booting.
You can choose any sampling
rate.
15
Advertisement
Table of Contents
