Replacing The Heat Sink - Lenovo ThinkCentre 3026 Hardware Maintenance Manual

8. Slide the power supply assembly to the front of the computer and then lift it out of the chassis.
Figure 52. Removing the power supply assembly
9. Install the new power supply assembly into the chassis so that the screw holes in the new power supply
assembly align with those in the chassis.
10. Install and tighten the four screws to secure the power supply assembly.
Note: Use only the screws provided by Lenovo.
11. Reconnect all the power supply assembly cables to the system board and each of the drives.
12. Secure the power supply assembly cables with the cable clips and ties in the chassis.
13. Go to "Completing the parts replacement" on page 123.

Replacing the heat sink

Attention
Do not open your computer or attempt any repair before reading and understanding the "Important safety
information" in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy
of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the heat sink.
CAUTION:
The heat sink might be very hot. Turn off the computer and wait three to five minutes to
let the computer cool before opening the computer cover.
To replace the heat sink, do the following:
108
ThinkCentre Hardware Maintenance Manual