Table of Contents
Advertisement
Fit the
screws in the desired set of holes
5
(A)
for 85, 88 or 90 cm worktop height
.
A)
STRATION
Lift the cooker back into the upright position
6
and connect it to the electrical supply. Push the
cooker into place and adjust its level (see below)
before fitting the safety equipment.
Levelling the cooker
The cooker must be level, for example to ensure that oil
in frying pans is of even depth. To check whether the
cooker is level, use a spirit level on the hob surround
(but not on the hotplates themselves). Check the level
first front to back and then side to side.
If necessary, you can lower (-6 mm) or raise (+12
mm) the wheels and feet, working from the front of the
cooker. Use a Phillips screwdriver to adjust the rear
wheels, and adjustable pliers for the front feet. Once
the cooker is properly level, you need to lock these feet
with the nut. Turn it anticlockwise using the spanner
supplied.
Electrical connection
Repairs and work on the cooker must be carried
out by a
QUALIFIED ELECTRICIAN
by unqualified persons can damage the cooker,
and may also lead to personal injury and/or
damage to property.
The connection options for the cooker are shown on
the plate on the rear of the cooker. Wattage and voltage
is stated on the rating plate (see the right-hand side of
the cooker).
(
-
SEE ILLU
. Work performed
2
1
Installation
19
Advertisement
Table of Contents
