Table of Contents
Advertisement
Installation
Work on the cooker must be carried out by a qualified
electrician. The cooker is heavy. Certain edges and cor-
ners which will not normally be exposed may be sharp.
when moving the cooker.
USE GLOVES
Before installing the cooker, you should check that its
dimensions correspond to the rest of your kitchen units.
Measure the height of the worktop from floor to top surface
of the worktop, and the plinth depth from the wall to the
front edge of the plinth (
be installed adjoining one wall, or one tall unit.
When delivered, the cooker plinth is adjusted to suit a
worktop height of 90 cm and a plinth depth of 55 cm.
Where necessary, you can alter the height of the plinth to
make the cooker suitable for a worktop height of 85 or
88 cm (see below). Check the cooker cable is not trapped
when moving the cooker.
To adjust the plinth height
1 Carefully lay the cooker on its front (
Use some of the packaging material to cushion the
cooker on the floor surface.
2 Take care: there are sharp edges on the underside
of the cooker. Unscrew screw A (1 screw) in the
centre rear of the plinth and the side screws B (4
screws,
SEE PICTURE
3 Push the plinth in to the required height setting,
90, 88 or 85 cm (
SEE PICTURE
4 Screw in screws A and B again.
Levelling the cooker
The cooker must be level, for example to ensure that oil
in frying pans is of even depth. To check whether the
cooker is level, use a spirit level on the hob surround (but
not on the hotplates themselves). Check the level first
front to back and then side to side.
If necessary, you can lower (-6 mm) or raise (+12
mm) the wheels and feet, working from the front of the
cooker. Use a screwdriver to adjust the rear wheels, and
adjustable pliers for the front feet.
Electrical connection
Repairs and work on the cooker must be carried out by
a
QUALIFIED ELECTRICIAN
fied persons can damage the cooker, and may also
leadto personal injury and/or
damage to property.
The connection options for the cooker are shown on the
plate on the rear of the cooker. Wattage and voltage is stated
on the rating plate (see the right-hand side of the cooker).
). The cooker may also
SEE PICTURE
SEE PICTURE
).
).
. Work performed by unquali-
55
).
B
A
B
90
88
85
B
85
B
Installation
90
88
15
Advertisement
Table of Contents
