Zanussi ZTE 280 User Manual page 11

programme knob to
the programme.
The display will
show 0.10
(corresponding to
the
programme).
2. Press the
button repeatedly
until the desired
programme
duration is shown in
the display, e.g.
00.20 for a
programme of 20
minutes. If the
programme
duration is not
selected, the
duration is
automatically set to
10 mins.
7 Start/pause
button
Press this button to
start the dryer after
having s elected the
programme and the
options.
The relevant light
will stop flashing. If
you have chosen a
delayed start, the
machine will begin
the count do wn.
If the door of the
appliance or the
small door at the
bottom is opened
while the
programme is
running, this
button must be
pressed again
after closing the
door in order to
restart the
programme from
the point at which
it was interrupted.
This button must
also be depressed
after a power
failure and after
having re-inserted
the water
reservoir, if it has
been emptied in
the middle of a
programme after
lighting up of the
light.
In both cases the
light of the
button flashes to
remind you that the
start button needs
to be pressed
again.
8 DISPLAY
The display shows
the following
information:
• duration of
selected
programme
• delayed start
• end of
programme
• incorrect option
selection
• alarm code
• Duration of
selected
programme
After you have
selected the
programme, its
duration (in hours
and minutes)
appears on the
display. It is
calculated
automatically on
the basis of the
maximum load
accepted for each
type of fabric and
of the required
degree of drying.
When the
programme starts,
the remaining time
is displayed every 5
minutes.
• Delayed start
If you have
selected a delay
time by means of
the relevant
button, the
display shows it
for 3 seconds;
then it shows the
duration of the
previously
selected
programme.
The countdown is
displayed every 30
minutes until it
displays "90
minutes" and then
hour by hour.
• End of
programme
A zero indicates
the end of the
programme and it
is displayed after
the "anti-creasing"
phase.
• Incorrect option
selection
If you select an
option that is not
compatible with
the programme
you have
selected, the
display show s Err
(error).
This code will
reappear during the
execution of the
programme if you
press one of the
option buttons or
turn the programme
selector.
• Alarm code
In case of a
functional
anomaly, the
display shows an
alarm code (e.g.
E21
). See page 19
for more detailed
information.
11