Advertisement
1
REMOVAL OF UTILITY BOX, AND
REAR GUARD (See Figure 1.)
NOTE: Before mounting your new bagger
you will have to remove the mower's utility
box and rear guard.
1. Remove the hairpins and clevis pins that
secure the utility box to the unit (all four
corners).
2. Using a 1/2" wrench, remove the six bolts
that secure the rear bracket to the unit.
BOLTS
FIGURE 1
2
MOWER DECK BAFFLE
(See Figure 2.)
1. Raise your mower deck to its highest posi-
tion.
2. Install the hex bolt, and locknut through
mower deck baffle and tighten securely.
LOCKNUT
MOWER
DECK
BAFFLE
FIGURE 2
ASSEMBLY
3
1. Using the 6 bolts removed from the rear
2. Place the hanger over the tab on the plate.
REAR BRACKET
3. Using the four bolts (HCS 3/8 x 3/4) and nyloc
4. Secure the hanger to the rear bracket with
HEX BOLT
INSTALLATION OF THE REAR GUARD,
PLATE AND HANGER
(See Figure 3A and 3B.)
bracket, install the new rear bracket (Part No.
110485).
See Figure 3A.
FIGURE 3A
nuts (3/8), install the plate to the rear bracket
and front bracket.
two bolts (HCS 5/16 x 3/4) and nyloc nuts
(5/16). See Figure 3B.
FIGURE 3B
7
Advertisement
