Husqvarna 1130SBEXP Owner's Manual page 6

ASSEMBLY / PRE-OPERATION
INSTALL TRACTION DRIVE CONTROL ROD
(See Figs. 3 and 4)
The traction drive control rod has the long loop on the end
of the spring as shown.
1. Slide rubber sleeve up rod and hook end of spring into
pivot bracket with loop opening down as shown.
2. With top end of rod positioned under left side of control
panel, push rod down and insert top end of rod into
hole in drive control bracket. Secure with retainer
spring.
PIVOT
BRACKET
TRACTION DRIVE
CON TROL LEVER
DRIVE
CONTROL
BRACKET
TRACTION DRIVE
CONTROL ROD
RUBBER
SLEEVE
LOOP
OPEN ING
DOWN
FIG. 3
RETAINER
SPRING
TRACTION
DRIVE
CON TROL
ROD
FIG. 4
INSTALL AUGER CONTROL ROD (See Figs. 5 and 6)
The auger control rod has the short loop on the end of the
spring as shown.
1. Slide rubber sleeve up rod and hook end of spring
into control arm with loop opening up as shown.
2. With top end of rod positioned under right side of
control panel, push down on rod and insert end of
rod into hole in auger control bracket. Secure with
retainer spring.
AUGER
CONTROL
ROD
RUBBER
SLEEVE
CONTROL
ARM
AUGER CONTROL ROD
6
LOOP
OPENING
UP
FIG. 5
AUGER
CONTROL
RETAINER
LEVER
SPRING
AUGER
CONTROL
BRACKET
FIG. 6