Belt Clip And Headset - Siemens Gigaset C455 User Manual

Initial charging and discharging of
batteries
Battery charging is indicated in the top right of
the display by a flashing battery icon
U
or . During handset operation, the battery
icon indicates the charge status of the batteries
(page 1).
The correct charge status can only be displayed
when the batteries are first fully charged and
discharged through use.
¤
To do this, leave the handset in the base
without interruption until the battery icon
stops flashing in the display (approx. 6h).
¤
Once the batteries are fully charged, remove
the handset from the base and do not put it
back again until the batteries are fully dis-
charged.
Note:
After the first battery charge and discharge you may
replace your handset in its base after every call.
Please remember:
u
Always repeat the charging and discharging
procedure if you remove the batteries from
the handset and re-insert them.
u
The batteries may warm up as they are
charging. This is not dangerous.
u
After a time the charge capacity of the bat-
teries will decrease for technical reasons.
Note:
You will find explanations for the symbols and typo-
graphical conventions used in this user guide in the
appendix, page 30.
Setting the date and time
¢ ¢
Settings Date/Time
§Menu§
~
Enter the day, month and year
with 6 digits and press
to move between the fields.
~
Enter hours and minutes with 4
digits (e.g. 0 7 1 5 for 07.15 hrs)
and press
between the fields.
Once the phone is registered and the time
set, the idle display looks as shown on
page 1.
Your phone is now ready for use.
Gigaset C455: Your answering machine is set
with a standard announcement.
e V
,
q
. Use
§OK§
q
. Use to move
§OK§

Belt clip and headset

By using a belt clip and headset (optional) you
can easily make your mobile phone a constant
companion both inside the building and in its
immediate vicinity.
Attaching the belt clip
There are notches for attaching the belt clip on
the side of the handset at approximately the
same height as the display.
¤
Press the belt clip onto the back of the hand-
set so that the protrusions on the belt clip
engage with the notches.
The belt clip's clasp must be pointing towards
the battery compartment.
Connection socket for headset
You can connect the following types of headset
(with jack connector): HAMA Plantronics M40,
MX100 and MX150.
First Steps
7