Setting Up The Handset For Use - Siemens Gigaset C470 User Manual

Connecting the base station
¤
First connect the power supply unit
and then the phone jack as shown
below and place the cables in the cable
recesses.
1
1
1 Mains adapter 230 V
2 Phone jack with phone cord
Please note:
u
The mains adapter must always be
connected, as the phone will not oper-
ate without mains connection.
u
Only use the mains adapter and phone
cord supplied.
u
If you buy a replacement phone cord,
make sure that the phone jack has the
correct type of wiring.
Correct phone jack assignment
3
2
1

Setting up the handset for use

The display is protected by
a plastic film. Please
remove the protective
film!
2
1 unused
4
2 unused
5
3 a
6
4 b
5 unused
6 unused
Inserting the batteries
Warning:
Use only the rechargeable batteries recom-
mended by Gigaset Communications GmbH *
(page 47). Never use a conventional (non-
rechargeable) battery or other battery types as
this could result in significant health risks and
personal injury. For example, the batteries
could explode. The phone could also malfunc-
tion or be damaged as a result of using batter-
ies that are not of the recommended type.
* Gigaset Communications GmbH is a trademark
licensee of Siemens AG.
¤
Insert the batteries the right way
round.
The polarity is indicated in/on the battery
compartment.
Closing the battery cover
¤
First insert the battery cover at the top.
¤
Then press the cover until it clicks into
place.
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.
First steps
7