Guarantee Certificate (Ireland) - Siemens Gigaset E150 Instructions Manual

This Guarantee shall apply to new devices purchased in the European
◆
Union. The Guarantee is issued by Siemens plc, Siemens House, Old-
bury, Bracknell, Berkshire, RG12 8FZ.
Any other claims resulting out of or in connection with the device
◆
shall be excluded from this Guarantee. Nothing in this Guarantee
shall attempt to limit or exclude a Customers Statutory Rights, nor
the manufacturer's liability for death or personal injury resulting
from its negligence.
The duration of the Guarantee shall not be extended by services ren-
◆
dered under the terms of the Guarantee.
Insofar as no Guarantee default exists, Siemens reserves the right to
◆
charge the customer for replacement or repair.
The above provisions does not imply a change in the burden of proof
◆
to the detriment of the customer.
To invoke this Guarantee, please contact the Siemens telephone serv-
ice. The relevant number is to be found in the accompanying user guide.

Guarantee certificate (Ireland)

Without prejudice to any claim the user (customer) may have in relation
to the dealer or retailer, the customer shall be granted a manufacturer's
Guarantee under the conditions set out below:
In the case of new devices and their components exhibiting defects
◆
resulting from manufacturing and/or material faults within 24
months of purchase, Siemens shall, at its own option and free of
charge, either replace the device with another device reflecting the
current state of the art, or repair the said device. In respect of parts
subject to wear and tear (including but not limited to, batteries, key-
pads, casing), this warranty shall be valid for six months from the
date of purchase.
This Guarantee shall be invalid if the device defect is attributable to
◆
improper care or use and/or failure to comply with information con-
tained in the user manuals. In particular claims under the Guarantee
cannot be made if:
– the device is opened (this is classed as third party interven-
tion)
– Repairs or other work done by persons not authorised by Siemens.
– Components on the printed circuit board are manipulated
– The software is manipulated
Appendix
73