Siemens Gigaset S455 User Manual page 11

First Steps
Opening the battery cover
¤
If fitted, remove belt clip.
¤
Insert a fingernail into the headset
socket cavity and pull the battery cover
upwards.
Placing the handset in the base station
and registering
¤
Place the handset in the base with its
display facing upwards.
The handset registers automatically. Reg-
istration takes around 1 minute. During
this time Regstr.Procedure
display and the name of the base station
flashes, e.g. 1. The handset will be
Base
assigned the lowest unassigned internal
number (1–6).
This will appear in the display when regis-
tration is complete, e.g.
that the number 1 has been assigned. If
the internal numbers 1–6 are already
assigned to other units, the number 6 is
overwritten.
Please note:
– Automatic registration is only possible
while no-one is making calls using the base
station.
– Each key press interrupts the automatic
registration.
– If automatic registration does not work the
handset will have to be registered manually
(page 37).
– You can change the name of the handset
(page 40).
8
appears in the
1. This means
INT
To charge the batteries, leave the handset
in the base station.
Please note:
– If the handset has switched itself off
because the batteries are flat and is then
placed in the base station, it will switch
itself on automatically.
– Only place the handset in the base or
charging cradle that is intended for it.
For questions and problems see page 49.
Headset socket
You can connect the following types of
headset (with jack connector): HAMA
Plantronics M40, MX100 and MX150.
Initial charging and discharging of
batteries
If the handset is activated, the flashing
battery icon e in the top right of the dis-
play indicates that the batteries are being
charged.
During handset operation, the battery
icon indicates the charge status of the bat-
teries (page 1). The correct charge level
can only be displayed if the batteries are
first fully charged and discharged.
¤
To do this, leave the handset in the
base or charging cradle continuously
for ten hours. Your handset need not
be switched on for it to charge.
¤
Afterwards, remove the handset from
the base station and do not put it back
again until the batteries are fully dis-
charged.