System Test After Installation; Calibration; Calibrating The Gala Curve - Blaupunkt TravelPilot DX-V Installation Instructions Manual

Installation

System test after installation

The system test allows you to test the external connections to
see that they are working correctly.
Proceed as follows:
1. Turn off TravelPilot DX-V
2. Press the button and keep it pressed.
3. Turn on the TravelPilot DX-V and release the
the service menu appears.
4. Using the button, select the test menu
OK button.
5. Now select the required test using the
the button and follow the on-screen instructions.
OK
If the test was completed successfully, the menu item will be
labelled with a tick. If an error occurs, an appropriate notice
will be displayed.
6. Close the service menu by pressing the

Calibration

After installation, the TravelPilot DX-V must be calibrated. You
will find the procedure for this described in the operating instruc-
tions.

Calibrating the Gala curve

After the TravelPilot DX-V is calibrated, the values that were
determined must be transferred to the control unit software so
button when that the Gala feature (sound-dependent volume adjustment)
works correctly.
and press the
Please proceed as follows:
or button, press
1. Turn off TravelPilot DX-V.
2. Press the
3. Turn on the TravelPilot DX-V and release the
4. Using the
button.
5. Close the service menu by pressing the
button and keep it pressed.
the service menu appears.
button, select the settings menu
the button. This procedure transfers the calibration val-
OK
ues that were previously determined to the control unit.
8
button when
and press
button.