Installing The Navigation Unit; Where To Install The Navigation Unit; Positive Connection; Negative Connection - Blaupunkt TravelPilot DX-V Installation Instructions Manual

Installation

Installing the navigation unit

Where to install the navigation unit

Important!
Before inserting the TravelPilot DX-V, you have to make sure
that the gyroscope is positioned horizontally (see Fig. 5,
page 14).
The TravelPilot DX-V can be installed in the car radio compart-
ment in the vehicle (installation depth 218 mm). You will need
an installation bracket (order no. 8 601 310 555) (see Fig. 1 page
13).
For vehicles without a DIN compartment, a universal equipment
housing has been included (see Fig. 1.1 page 13). Check to see
which method of installation is required for the vehicle and, if
necessary, use a vehicle-specific installation kit.
When selecting an installation location, you must remember that
the navigation unit has to be built into the vehicle body.
Installation position:
right / left
slope to the rear
A fan has been built into the back of the unit to cool it when
it overheats. To allow for sufficient air circulation, make sure
that the air vents are not blocked. Use only the hole strips
to attach the unit to the mounting bolt.
Make sure that there is enough room to insert and remove the
navigation CD.
Allgemeines Kurzanlei-
min. -5˚ / max. +5˚
min. -3˚ / max. +100˚
Zieleingabe Touren

Positive connection

Connect the navigation unit to continuous plus and the positive
connection to the ignition.
Lay the continuous plus wire (red) to the battery (do not lay the
wire directly along any wire harnesses). Connect a fuse holder
to protect the positive wire at a maximum of 30 cm from the
vehicle battery (if necessary, drill a hole in the splashback and
use the necessary wire bushing).
Connect the switching plus wire (black) to terminal 15 on
the fuse holder (plus is switched by the ignition) behind the
fuse.

Negative connection

Screw the negative wire (brown) directly to the vehicle body.
Scratch the contact points on the ground down to the metal and
grease it with graphite grease (important for a good ground).

Installing the GPS antenna

Install the antenna according to the enclosed instructions.
If the GPS antenna is installed inside the vehicle, there is no
guarantee that the system will function properly.
Zielspeicher Einstellun-
5
Anhang