Planning The Installation; Preparation For Installation; Additional Accessories Needed For Installation; Stove Installation Considerations - Lopi Answer Owner's Manual

Stove Installation
SAFETY NOTICE:
Please read this entire manual before you install and use your new room heater. Failure to
follow instructions may result in property damage, bodily injury, or even death. Contact
local building or fire officials about restrictions and installation inspection requirements in
your area.

Planning The Installation

We suggest that you have an authorized Travis Industries dealer install your stove. If you install the
stove yourself, your authorized dealer should review your installation plans.
Check with local building officials for any permits required for installation of this stove and notify your
insurance company before proceeding with installation.

Preparation for Installation


Check for damage to the exterior of the stove (dents should be reported, scratches can be fixed by
applying touch up paint).

Check the interior of the firebox (replace cracked firebrick and make sure baffle is in place).
The stove can be lightened by removing the firebricks and baffle (pg 33) - replace before operation.

Additional Accessories Needed for Installation


Door Shell (Black 99300195 Brass 99300196 or Pewter 99300197 - see pg 37)

Legs or Pedestal

Stove Installation Considerations

The table below details the six most common types of installations and the considerations for each type.
Alternative methods of installation are available if they comply with local building codes.
Installation Type
Standard Ceiling with a Factory Built Chimney
(Page 15)
Cathedral Ceiling with a Factory Built Chimney
(Page 15)
Exterior Factory Built Chimney
(Page 16)
Hearth Stove Positive Connection (Page 16)
Hearth Stove Direct Connection (Page 17)
NOT APPROVED IN CANADA
Interior Masonry Chimney (Page 17)
NOT APPROVED IN CANADA
© Travis Industries
(for qualified installers only)
Considerations

Requires ceiling and roof penetration

Provides best draft

Cathedral style chimney support required

Provides best draft

Uses two elbows to route chimney outside

Exterior chimney is hidden from the room

Elbows reduce draft

Optional exterior chase reduces cold air blockage

Utilizes existing masonry or zero clearance (metal) chimney

Provides good draft due to full reline

Easier to clean than direct or horizontal hearth stove

Utilizes existing masonry or zero clearance (metal) chimney

Requires construction of a "block-off plate"

Draft reduced due to elbows & chimney cross section

Utilizes existing masonry chimney (not approved for zero
clearance (metal) fireplaces)
100-01166
7
4040907