Electrical Connection - Tricity Bendix HG 250 Instruction Booklet

Gas hob
Table of Contents

Advertisement

ELECTRICAL CONNECTIONS
All electrical connections must be carried out by
competent persons in accordance with the current
regulations. This appliance is designed to be
connected to a 240V 50Hz AC electrical supply.
The appliance is fitted with a 3 core flexible supply
cord incorporating a moulded 3amp plug top fitted
with a 3amp ASTA rated fuse.
THIS APPLIANCE MUST BE EARTHED.
The manufacturer will not accept liability should
this safety measure be ignored.
If the plug that is fitted to your appliance is not
suitable for the socket outlet, it must be cut off and
the appropriate plug fitted.
The cut off plug should be disposed of to prevent the
hazard of electric shocks should it be plugged into a
13amp socket elsewhere in the house.
IMPORTANT
The wires in this flexible supply cord are coloured in
accordance with the following code:
Green and Yellow
Blue
Brown
To fit the plug, the colours of the wires in the flexible
supply cord may not correspond with the markings
identifying the terminals in the alternative plug. In this
case follow the procedure below:
-
Connect the green and yellow (earth) wire to the
terminal in the plug which is marked with the letter
'E' or the earth symbol
yellow.
-
Connect the blue (neutral) wire to the terminal in
the plug which is marked with the letter 'N' or
coloured black.
-
Connect the brown (live) wire to the terminal in
the plug which is marked with the letter 'L' or
coloured red.
- Earth
- Neutral
- Live
or coloured green and
When replacing the plug top fuse only a 3amp
BS1362 ASTA rated replacement should be used.
The plug must not be used if the fuse cover/carrier is
lost.
A replacement cover/carrier must be obtained from a
Zanussi Service Force Centre. (See rear of user
instructions for address and telephone number of
your local centre).
This appliance complies with E.E.C. Directive
No.89/336 relative to radio interference
suppression.
IMPORTANT
Ensure that the hob supply cord does not come into
contact with surfaces with temperatures higher than
50 deg. C.
FO 0390
15

Advertisement

Table of Contents
loading

Table of Contents