Table of Contents
Advertisement
INSTALLATION ABOVE CUPBOARD OR DRAWER
If the hob is to be installed above a cupboard or
drawer it will be necessary to fit a heat resistant
board below the base of the hob on the
underside of the work surface.
A
ON/OFF SWITCH
FLEX
OUTLET
FO 0763
BUILDING IN KITCHEN UNIT WITH DOOR
Proper arrangements must be taken in
designing the forniture unit, in order to avoid any
contact with the bottom of the hob which can be
heated when it is operated. The recommended
solution is shown in inllustration C.
The panel fitted under the hob ("a") should be
easily removable to allow an easy access if a
technical assistance intervention is needed. The
space behind the kitchen unit ("b") can be used
for connections.
FITTING THE HOB TO THE WORKTOP
Before fitting the hob into the cut out, an
adhesive seal must be fitted to the underside
outside edge (Fig. 3) of the hob. It is essential
that no gaps are left in this seal in order to
prevent spillage near the hob seeping into the
cabinet below.
1) Remove the pan supports, the burners caps
and crowns and turn the hob upside down,
taking care the ignition candles are not
damaged in this operation.
2) Place the sealing gasket all around the glass
top edge as shown in Fig. 3.
3) Fit the hob in the cut out and push it down
until the glass top and the working top come in
touch, as shown in Fig. 4
It is also recommended to carry out the electrical
connection to the hob as shown in illustrations A
and B.
B
ON/OFF SWITCH
FLEX
OUTLET
FO 0764
C
60
FO 1013
FO 2108
Fig. 3
FO 2107
Fig. 4
a
b
A
a) Sealing gasket
13
Advertisement
Table of Contents
