Table of Contents
Advertisement
INSTALLATION
IMPORTANT
It is essential that a competent installer is
employed to fit this appliance.
The manufacturer will not accept liability, should
the above instruction or any of the other safety
instructions incorporated in this book be ignored.
On the end of the shaft, which includes the GJ
1/2" threaded nut, adjustment is fixed so that the
washer is interposed between the components
as shown in Figure 1. Screw the parts together
without using excessive force, orientate the
adjustment in the desired direction and then lock
it all together.
Connection to the gas supply should be with
either rigid or semi-rigid pipe, i.e. steel or
copper.
The connection should be suitable for
connecting to RC 1/2 (1/2 BSP male thread).
When the final connection has been made, it is
essential that a thorough leak test is carried out
on the hob and installation.
Ensure that the main connection pipe does not
exert any strain on the hob.
FO 0264
A) End of shaft with nut
B) Washer
C) Adjustable join
It is important to install the elbow correctly,
with the shoulder on the end of the thread,
fitted to the hob connecting pipe.
Failure to ensure the correct assembly will
cause leakage of gas.
12
Rectangular cut-out size for hob
FO 2109
FO 0814
Fig. 1
f using flexible metallic pipes, be careful they
I
do not come in contact with mobile parts or
they are not squeezed. Use the same
attention when the hob is combinated with an
oven.
Fig. 2
Advertisement
Table of Contents
